Hello, everyone.

This is Enta.

How do you measure the finished dimensions of a formwork frame?

As mentioned above, I generally secure the zero point lightly with concrete nails.

We set these up in pairs (left and right) to take measurements.

 

Measuring the finished dimensions of a paste frame is basicallyinMeasuring with the core of the mounting frameI will.

Some people often measure from one far right end to the other, for example.

It's not great. Basically, the core is the standard.

After all, the construction plan specifies that measurements should be taken at the centerline, right?

 

What matters most is what is written in the construction plan, so please follow it.

If you don't include it, it could be pointed out during the final inspection.

You might be wondering, “Why does the measurement method differ from the construction plan?”

It’s better to measure using the core so that you don’t end up saying something like that.

 

I often write about my medical exams.

Even as a construction company, we believe it goes without saying that we should prioritize this aspect in our work.

It doesn't end once work on-site is finished, so I'm very concerned about the process leading up to completion.

With first-tier subcontractors, I’m usually there on-site, so it still gives me a sense of security, lol.

As for the width and height of the border, they don't vary much no matter where you measure, so I'll leave it up to you lol

Unless something extraordinary happens, I don't think the figures will fall below that level.

However, please be wary of contractors who cut the bottom of the mesh when assembling the nori frames.

If there are large rocks or other objects on the slope surface, cutting without bending the blade will result in the cut being too short.

 

And above all, quality control is a real pain. But hey, it's part of the job! lol

There's no single "best" measurement method, but the easiest one is usually the best—though it is a real hassle, lol.

I'd like to know if there's a better way.

I also tried connecting two measuring staffs and clamping them between the edges of the paper, but it didn't really work out lol.

Or maybe you could just make a tool that makes it easier to measure this? *grin* lol

Of course, I do have a few ideas, but we'll need to test them out.

Measuring the finished product really is a lot of work.

Measuring finished products by myself is seriously a drag, lol. (I know, I know—if you say, “That’s your job!”—you’re right.)

 

Make your work a little easier and more accurate!

That's the way to go, isn't it?

 

See you later.