Hello, everyone.
This is Enta.
Here are the vise pliers used for cement slurry injection that I introduced earlier!
Do you remember?
Slip the pressure-resistant hose over the injection hose, then snap the trimmed vice-pliers into place, and
It's a product that doesn't require you to tighten each individual screw.
This is what the quality used to be like.
Since Enta uses 1-inch pressure-resistant grout hoses, we made ours smaller than that.
Up until recently, there were some minor leaks and the quality was a bit inconsistent lol (though it wasn't really a big deal lol).
However, after some trial and error, I've finally managed to create something at this level!
I actually used this for the injection, and the fit was absolutely perfect.
We’ve also purchased and modified products from this company, so we cannot sell them. (Patents and design patents)
Plus, I haven't even gotten permission yet, lol
There's no problem as long as you're purchasing it for personal use and modifying it yourself.
However, things have gotten a lot easier since I started using this.
It's quite a hassle to bundle them together with wire, after all.
Even if the hose is a small 6-bun size, we can handle it with a slightly smaller model, lol.
If you're using Track X, please try creating one.
Since this involves modifications, I think it would be problematic to discuss it publicly, so I'll send you the details via email.
If you'd like to create one, please send me an email.
See you later.
