Hello, everyone.

This is Enta.

Starting today, I’m officially on my Obon break.

I don't really have any plans to go back to the countryside, but actually, I want to get some paperwork done... lol

Turns out I'm working after all lol

It's really tough to juggle construction work and paperwork, isn't it?

---

But that's beside the point.

Mastering Stress Management!

I've covered the topic of stress management quite a bit on this blog.

That’s because so many people think managing anxiety is incredibly difficult, and as a result, many are reluctant to try it.

It's actually very simple.

All you have to do is pull the PC strand. They're just making it sound a little more complicated and confusing than it really is, aren't they?

I'm planning to write this as another series, so please stick with me. lol

I'll start by writing down what to do, in order.

1. Stress Management Plan

This comes first.

Based on the design stress, the loads for the qualification and verification tests are determined, and the loading method is established.

We'll also decide on everything, including where and how many aptitude tests to administer.

We will conduct the test in accordance with this plan.

2. Tension Member

We'll conduct the drill at the actual site.

Place the jacks against the structure to be pressurized and apply tension (pressure).

At this point, the load specified in the plan is gradually increased and decreased to measure the elongation of the prestressing steel strands.

3. Stress Management and Document Organization

This is the part that people say is a bit tricky.

The tension control charts are particularly tricky, aren't they?

Since I’ve been writing since the days of handwriting, it comes easily to me (or does it? lol), but it does take some getting used to.

The reason is that a key aspect of the stress management described above is

The elongation of the PC steel strands falls within the upper and lower limits of the theoretical values.That's it.

So, we need to prepare that as a document.

 

Here's a rough breakdown.

It's actually surprisingly easy to do.

And once you've created the documents, all you have to do is tweak them a bit to fit the anchor materials, so it's a piece of cake.

I think you'll eventually realize that ground anchor work isn't that difficult.

 

See you later.