Hello, everyone.
This is Enta.
LatelyWe're getting more and more inquiries from our blog!
Thank you.
When I get inquiries like this, it makes me glad I’ve been sharing this information.
We will continue to share updates as always.
My hope is that you’ll read this blog, put the advice into practice, and see results.
And,A Record of My Own ConfessionsBut there's no doubt that's the case, lol.
There's not much of the year left—let's keep pushing forward!
But that's beside the point.
In a recent article, I introduced the Thunder Blade.
This is the blade for cutting PC steel wire!
The blade that President F—who saw it—sent me, saying, “Please try this out,” has arrived!
The kind of thing where a challenger appearsThat's it!
Part 2 is about to begin!
The Challenger of the Cutting Wheel (Part 1)
This is the product I recommend!
So, to test this, I'll proceed in the same way as last time.
1. Measure the diameter of the unused item
2. Cut the PC wire in five places (PC wire diameter: 15.2 mm)
3. Measurement of Cutting Time
4. Measure the diameter after use
5. Impressions of the User Experience
So, let's start by taking some measurements.
The diameter is107 mm
Just like last time, I'll cut these in order!
Please watch the cutting process at 3x speed.
*Please be mindful of the volume, as sound will play.
What do you think?
The exact time is43.63 seconds
The diameter after cutting is101 mm
My impression is that it cuts well, just as expected.
It cuts through things crisply, just like always.
And this isn't going down as expected either. It doesn't feel like it's going down.
107 mm – 101 mm = 6 mm. Five pieces will reduce the length by 6 mm.
Per strand: 6 mm ÷ 5 strands = 1.2 mm
When the effective cross-sectional area is set to 25 mm,
25 mm ÷ 1.2 mm =
Based on these calculations, it should be possible to cut 20.8 strands of PC wire.
It has been proven once again that the theory that the Delta Cut is the strongest remains unshakable.
Next time, we'll go over some important points.
See you later.
