Hello, everyone.
This is Enta.
It's been really cold since the other day!
Back in the day, they were called "steteko," but these days, they're a must-have as underwear, aren't they?
When it comes to wearing these undershirts for work, some are suitable for the job, while others are not.
Underwear suitable for work should not contain rayon fibers.That's it.
That's because rayon is highly absorbent, so it soaks up sweat. And it takes a long time to dry.
That means you'll get chilled from your sweat. In sub-zero temperatures, sweating can be deadly, right?
Since UNIQLO's HEATTECH contains rayon, I don't think it's suitable for work.
When looking for underwear,Items that do not contain rayonPlease select one.
They're a bit pricey, but they last an incredibly long time. They range from 2,000 yen to just under 5,000 yen.
I like GeoLine products from Montbell and other brands.
But that's beside the point.
Here is the final announcement for the "Battle for the Top" cutting wheel competition that has been going on for the past few days.
The Challenger of the Cutting Wheel (Part 1)
The Challenger of the Cutting Wheel (Part 2)
Let's take a look at each piece of data.
Data from cutting 15.2 mm PC steel wire five times
| Product Name | It's about to snap! | Delta Cut |
| Diameter: Before cutting | 105 mm | 107 mm |
| Diameter: After cutting | 96 mm | 101 mm |
| 差 | 9.0 mm | 6.0 mm |
| Cutting Capacity (1 piece) | 1.8 mm | 1.2 mm |
| Effective Cross-Section | About 25 mm | About 25 mm |
| Number of PC strands that can be cut | 13.8 books | 20.8 books |
| Cut Time (5 pieces) | 47.29 seconds | 43.63 seconds |
| Cutting Time (1 piece) | 9.458 seconds | 8.726 seconds |
| Price (10 sheets) according to Monotaro | 1,079 yen | 1,717 yen |
| Price (per sheet) | 108 yen | 172 yen |
| Cost per cut | 7.8 yen | 8.2 yen |
| Price for cutting 1,000 pieces | 7,800 yen | 8,200 yen |
| Time taken to cut 1,000 pieces | 2 hours, 37 minutes, and 38 seconds | 2 hours, 25 minutes, and 26 seconds |
| Cut Time Difference | 12 minutes and 12 seconds | |
I used Monotaro's prices, but I found some places that were a little cheaper.
We used Monotaro's prices to ensure consistency.
As you can see from the results above, it’s surprisingly—or rather, incredibly—sharp!
In terms of value for money, Kireru Nja had the edge.
Delta Cut was excellent in terms of performance, but will the Njaa—which offers the best value for the money—ultimately come out on top?
In real-world situations, it takes time to change the grinding wheel, so it’s not exactly the same as the pure time, but I’m satisfied with the interesting results lol.
This really is what self-indulgence is all about, lol.
However, I am extremely grateful, as this would not have been possible without President F’s cooperation.
Thank you very much.
And next time, I'll be testing the other blade you sent me lol
ThisIt's about to snap!For inquiries, please contact us here
Fujiwara Industries Co., Ltd.
Phone: 06-6683-0797
See you later.
