Hello, everyone.
This is Enta.
Maybe it's because of the flu? My nostrils are completely blocked lol
I just can't stay focused lol
It really makes you go, "Aaaahhh..."
Please be careful, everyone!
But that's beside the point.
Since then, I've been looking at the shape of the anchor head.
Then the shape of the head becomes,
It's kind of like this, isn't it? lol
I was a little unsure, so I compared it with the diagram I made the other day.
Just get the general idea—that's all that matters.
It looks like it's going to hit right where the steel wire is strongest.
Perhaps it would be better to adjust it to fit this shape, as it should be?
I've made a few minor corrections,
This is what the 3D data ended up looking like. Rounding the corners makes it a little thinner, so it might actually be a bit of a mixed bag...
When printed, the thinnest part is about 2.5 mm.
I've decided to go for it.
Since it's plastic and a consumable, I'll go ahead and print this as a test for now.
I'll include the numbers as well, so it's easy to tell which steel wire is which.
If everything goes well, I'll share some photos of the experiment and such.
See you later.
I'm looking forward to seeing the results. It might be a good idea to add some thickness and give it a slight taper.
Thank you as always.
I thought about making it thicker, but since it’s a 3D-printed model, I decided to keep the material usage to a minimum for now lol.
I'd be happy if this works out... lol. I'll let you know how it goes!