Hello, everyone.
This is Enta.
Survey for Reinforcing Bar Installers (Required for Contractors)
If the above...Survey on Reinforcing Bar Installation WorkersIf you haven't responded yet, please be sure to participate.
I'm going to leave this up for a while, so I'd like to hear your thoughts.
It's completely anonymous.
Thank you in advance.
But that's beside the point.
"Kantan-kun," which I bought the other day after it was recommended to me
Did you know that? lol
The name makes you wonder, “Is this naming style straight out of the Showa era?!” but as a product, it was actually pretty simple lol.
This product locks the grout hose in place during injection.
I actually tried using it on-site.
Just plug in the hose, turn the orange lever a few times, and lock it in place.
Here's how to use Kantan-kun.
Here's a tip: Try to push the hose as far back as possible.
And if you close it firmly, it will lock into place.
Please note that there are two sizes of hoses, so be careful when placing your order.
Please note that sizes are available for 17 mm and 21 mm.
I believe 21 mm is the standard size for a typical injection hose (ground anchor).
The video above also uses the 21mm version.
It might be a good option because it’s easier to use than the one on Track X.
However, if it is not tightened securely, it may come loose, so please install it properly.
By the way, I purchased it after being introduced to it by Mr. Muraoka from Kimoto Rubber Industries.
Please direct any inquiries to Mr. Muraoka at Kimoto Rubber.
It was easy to make, so the Vietnamese people at our place were happy to use it.
See you later.
