Hello, everyone.
This is Enta.
It seems some of you have already started work for the year, and,
I've been getting a ton of phone calls since the other day.
I truly appreciate your support.
When I say that, people laugh at me lol
I'm surrounded by wonderful people who are always there to help me.
Thank you.
But that's beside the point.
How a Clip Spacer Is Made (Part 1)
How Clip Spacers Are Made (Part 2)
This is the first version of the clip spacer. (The prototype is unplated.)
I was moving in all four directions just to stay in the center, lol.
But haven't you seen this somewhere before??
Actually...
Actually, it turned out to be a hose clip I happened to find at a home improvement store.
Since standard hose clamps cannot secure rebar,
(After making quite a few fine adjustments), I had it cut to D19 size.
Once we had produced more than 20 experimental prototypes, the product was essentially ready for use.
But if the tip is rounded like in the photo, it slips on the mortar!
I made about three prototypes to figure this out.
It's just a small thing.
In this world,Everything gets resolved with just a little somethingThat was when I truly realized it.
You'll find all the answers at the home improvement store!
This is one of the answers I came up with, lol.
Actually, whenever I run into a problem or feel stuck, I go to a home improvement store.
Works by developers from all over the world are on display here.
When I look at them one by one, it somehow gives me courage.
The developer agonized over and over againFrom ScratchI'm working hard to create a "1"!
At this point, whether it sells or not doesn't matter—I just want to provide something useful!
I find myself wanting products that are easy to use and allow me to get the job done as quickly as possible.
See you later.
I’ve already asked them to help me out at the next job site~!(^^)! I’ll stop by to say hello again~( 一一)
I look forward to your continued support this year.
Thank you!