Hello, everyone.
This is Enta.
The crack test is about to begin.
I gave it a try like this.
From left to right
Left: No spacer 3
Center: Steel Spacer 2
Right: Plastic spacer 1
The numbers were written on the mortar after it was sprayed.
The box is 12 centimeters, and the spacer is 10 centimeters.
I wiped down the top of the box and applied the iron at a distance of 10 centimeters.
This is the part where the spacer's head is just barely visible—or not visible at all.
You wouldn't use a spacer—which is normally used for sprayed mortar and the like—to apply the trowel, would you!?
You might think that, but it's a choice that's prone to cracks.
If the surface is uneven, like with standard sprayed mortar, cracks are hard to see, so it’s easier to spot them if you use a trowel to create visible cracks.
Under the worst possible conditions.
I curled all of it perfectly to 10 centimeters lol
This is the kind of atmosphere it has.
I guess I'll just leave it like this for a while.
I'll remove the mold after Golden Week is over.
The sand at this site is pretty fine, so I'm really looking forward to seeing how this turns out lol
There's also a video of the spraying in progress, so I'll post it tomorrow or so.
See you later.
