Hello, everyone.
This is Enta.
Here's how to make a hose clamp, which a lot of you have been asking for lol
It's actually very easy to make, but,
Please get the largest pair of vise pliers you have.
And I think the cheapest one will be just fine.
Actually, the Amazon link above might be the cheapest option.
It's fine if it's something sold at a home improvement store or similar place.
Since it will be processed, I think you should treat it as a consumable item.
Here's how to process it.
PROCHI PRC-DF33 (JFC-)DF Carbide Hole Saw, 33 mm
Horsow bought this on Amazon lol
Everything on Amazon!
When you factor in shipping costs and everything, it actually ends up being cheaper, doesn't it?
Other than that, if you have a drill press or something, it's easy to drill holes.
Drill a hole, use a sander to remove the burrs, and—if possible—degrease the surface before painting to prevent rust.
When using it, it’s best to grip it tightly with both hands.
It has never come loose due to pressure, but there was one time when it fell to the ground by accident and the lock came undone.
Just be sure to handle it with care, or keep the lock facing upward.
Also, if you're concerned about pressure, it's safer to install two of them, one vertically and one horizontally.
See you later.
