Should the road be sloped or level when installing ground anchors or reinforcing bars?
Hello, everyone. This is Enta. Which is better for ground anchor installation and rebar insertion: installing formwork or pressure plates? Why it’s best to install formwork level (horizontally) on-site. I’ve written about this before, but the same applies to formwork, lol. Road gradient…
Determining the Placement Location for Ground Anchor Installation
Hello, everyone. This is Enta. How do you go about positioning ground anchors during installation? I get asked about this quite often, so I thought I’d write about it this time. The drawings are actually quite vague on this point. That said, when it comes to the design cross-section…
If the machine is too low to place the concrete in the designated position, raise it!
Hello, everyone. This is Enta. We’ve been carrying out drainage boring work in Shizuoka as part of landslide prevention measures for the past few days. You know how it is—even when the construction location is set, sometimes the machine is positioned too low to align with the drilling spot. In practice, we set it a bit lower and use scaffolding…
Placement Locations for Rebar Insertion Workers | An Approach to Solving Difficulties Through Lateral Extension
Hello, everyone. This is Enta. Do you know the basic principles behind rebar placement? You often see areas where concrete is poured and others where it isn’t, right? As long as the foreman is aware of this, there’s usually no problem, but there are often situations where you wonder, “What should we do here?” or…
How to Determine the Placement Location for Rebar Insertion | Marking Procedure
Hello, everyone. It’s Enta here. Since it’s Sunday, this is just a copy-and-paste post from Ameblo, lol. A lot happened last week, and I’m completely wiped out. There are good times and bad times, I guess. I’ll do my best! Anyway, moving on—this is about how to determine the placement of rebar during concrete pouring. …