About half the initial load

(Just before the jack is fully raised)

Check the position of the pressure-receiving plate, the position of the angle adjustment base, and the position of the pressure-receiving plate.

 

Initial Load

Double-check the position and level of the pressure plate

 

Static Load

I take a deep breath and tense up.

For ring heads + wedges, apply a single unloading cycle at the set load (to drive the wedge in).

After that, reapply the holding load and rotate the ring.

 

The nut-type fastener also secures firmly after being tightened twice.

Use a chisel and hammer to tap it firmly into place.