{"id":51326,"date":"2024-05-06T08:00:12","date_gmt":"2024-05-05T23:00:12","guid":{"rendered":"https:\/\/norimen.net\/wordpress\/?p=51326"},"modified":"2026-05-16T14:49:31","modified_gmt":"2026-05-16T05:49:31","slug":"order-for-installing-and-removing-temporary-anchors","status":"publish","type":"post","link":"https:\/\/norimen.net\/en\/temp-anchor-install-remove-order\/","title":{"rendered":"Sequence for Installing and Removing Temporary Ground Anchors"},"content":{"rendered":"

Hello, everyone.<\/p>\n

This is Enta.<\/p>\n

\"Rotary<\/p>\n

What happens after temporary anchors are installed?<\/p>\n

Well, of course, since this is a temporary structure, we\u2019ll take it down once the permanent construction is complete.<\/p>\n

 <\/p>\n

We are removing the items in the reverse order in which they were installed.<\/p>\n

In the photo, the structure is being installed from the top, the ground below is being excavated, and temporary anchors are being driven into the ground at the base.<\/p>\n

Therefore, we will remove the temporary anchors at the bottom and backfill the area with soil.<\/p>\n

After that, the upper anchors will be removed, the area will be backfilled, and the sheet piles will be extracted.<\/p>\n

\"Steel<\/p>\n

Removal is relatively simple; just cut through the back of the steel pressure plate with an angle grinder.<\/p>\n

Since PC steel strands are basically U-shaped, there are always an even number of them.<\/p>\n

Once you've cut it in half, everything has been unloaded.<\/p>\n

 <\/p>\n

However, for now, we will cut all the pipes and remove the steel pressure-bearing components.<\/p>\n

\"Cross-section<\/p>\n

People often say it\u2019s better to cut with a gas torch here, but I think an angle grinder is better.<\/p>\n

That's because with a gas cutter, the cut surface melts, so you'll have to cut it again with an angle grinder when you move on to the next step.<\/p>\n