<\/p>\n
Due to the structural design of the load-bearing structure, the load is concentrated in the area closest to the anchor body.<\/p>\n
If it's a pressure-receiving plate, it's at the center.<\/p>\n
In addition, the structure of the pressure-receiving plate is generally wider in the center.<\/p>\n
It's shaped like an \"H,\" isn't it?<\/p>\n
That means if the center (the area around the center of the anchor body) is raised slightly, the edges will fit together more snugly.<\/p>\n
Actually, it\u2019s best to use a spacer board to make it symmetrical on both sides and along the diagonals, but that\u2019s quite difficult.<\/p>\n
However, if the center is about 1 cm higher, it may not work properly, so aim to keep it at 1 cm or less\u2014preferably around 0.5 cm or less\u2014as much as possible.<\/p>\n
So that means the difference between the highest and lowest points is less than 0.5 cm... lol<\/p>\n
Well, that makes it easier to get the timing right, so you'll get the hang of it after trying it a few times.<\/p>\n
You'll need a long, straight piece of wood!<\/span><\/strong><\/span><\/p>\n The illustration above is drawn to make it easy to understand.<\/p>\n It\u2019s easier to make the pressure-receiving plate lower (0.5 cm or less) toward the edges from the center.<\/p>\n If you can create a perfectly flat surface, you'll have no problem.<\/p>\n <\/p>\n After that, we\u2019ll be applying it with a pretty lean mix, but won\u2019t it end up looking a bit like sprayed mortar? lol<\/p>\n Since pressure is applied, a lean mix is sufficient; however, due to the risk of erosion from rainfall, we recommend using a sturdy mortar for the surrounding area.<\/p>\n So, does that mean mortar after all? LOL<\/p>\n There's a recommended mix ratio for zabuton frames, but I've hardly ever used it, lol.<\/p>\n <\/p>\n See you later.<\/p>\n <\/p>","protected":false},"excerpt":{"rendered":" Hello, everyone. This is Enta. Sometimes we install cushion frames to level out unevenness in load-bearing plates. It\u2019s quite a hassle, but as far as leveling goes, it\u2019s definitely the way to go right now. Who knows what the future holds, though!? *grin* The assembly part isn\u2019t that big of a deal\u2026<\/p>","protected":false},"author":2,"featured_media":2861,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"_acf_changed":false,"_bbp_topic_count":0,"_bbp_reply_count":0,"_bbp_total_topic_count":0,"_bbp_total_reply_count":0,"_bbp_voice_count":0,"_bbp_anonymous_reply_count":0,"_bbp_topic_count_hidden":0,"_bbp_reply_count_hidden":0,"_bbp_forum_subforum_count":0,"footnotes":"","jetpack_post_was_ever_published":false},"categories":[37,28],"tags":[114,261,262],"class_list":["post-2860","post","type-post","status-publish","format-standard","has-post-thumbnail","hentry","category-mortar-spraying","category-ground-anchor","tag-114","tag-261","tag-262"],"acf":[],"yoast_head":"\n![\"\"](\"https:\/\/norimen.net\/wordpress\/wp-content\/uploads\/2017\/03\/101878ebbd1bcb562efdc50e79613521.jpg\")
<\/p>\n