{"id":2473,"date":"2017-02-01T08:00:30","date_gmt":"2017-01-31T23:00:30","guid":{"rendered":"https:\/\/norimen.net\/wordpress\/?p=2473"},"modified":"2026-05-17T11:54:53","modified_gmt":"2026-05-17T02:54:53","slug":"the-inspector-expects-too-much","status":"publish","type":"post","link":"https:\/\/norimen.net\/en\/inspector-expects-too-much\/","title":{"rendered":"When inspectors demand too much during inspections, it wears down the staff on the ground!"},"content":{"rendered":"

Hello, everyone.<\/p>\n

This is Enta.<\/p>\n

 <\/p>\n

We had a final inspection the other day.<\/p>\n

Well, on-site, we just did the usual checks\u2014verifying the building permit, checking the building frame, and inspecting the exterior.<\/p>\n

That's pretty standard.<\/p>\n

The vegetation installed by the landscaping contractor also grew well.<\/p>\n

Of course, this is a site where we experimentally incorporated green spacers as part of our innovative approach.<\/p>\n

Landscaping Spacer<\/a><\/span><\/strong><\/span><\/p>\n

 <\/p>\n

And now, it's time for the document check.<\/p>\n

You're saying the design angle relative to the perpendicular of the slope is wrong!<\/span><\/strong><\/span><\/p>\n

 <\/p>\n

The design angle is perpendicular to the slope, but...<\/p>\n

To determine the perpendicular to a slope, measure the slope's angle.<\/p>\n

For example, if the slope face on which rock bolts are installed has an angle of 56\u00b0,<\/p>\n

90\u00b0 minus 56\u00b0 equals 34\u00b0<\/span><\/strong><\/p>\n

The design angle is 34\u00b0.<\/p>\n

We calculate (measure) the design values during installation and then take actual measurements after drilling the holes.<\/p>\n

After that, we conducted construction management to calculate the difference between the actual measurements and the design values.<\/p>\n

\"\"<\/p>\n

The inspector is saying that since there are no specific figures in the design, shouldn't the design values be submitted to the government office in advance?<\/p>\n

Construction should proceed only after obtaining approval for it.<\/p>\n

That was the gist of it.<\/p>\n

So you're telling me to measure all the angles first after installing the door frame? LOL<\/p>\n

The lack of uniformity in inspectors\u2019 management standards and the discrepancies in their approaches\u2014these are issues I\u2019d really like to see addressed.<\/p>\n

 <\/p>\n

See you later.<\/p>\n

Quality Control for Formwork Construction | Sequence from Lathing to Completion of Spray Application<\/a><\/p><\/blockquote>\n